Thingiverse
Fpv antenna cover
by jsledge
5
Downloads
5
Likes
0
Makes
Printed on a Tevo Tornado. 0.2mm with 20% infill with PLA.
- Removed any plastic from the broken antenna cap.
- Put some glue in the center of the base.
- Slide it on the antenna.
- Put glue around the base of the cap and pushed the cap in place.
- Fixed in place with rubber bands until the glue was dry.
- Removed any plastic from the broken antenna cap.
- Put some glue in the center of the base.
- Slide it on the antenna.
- Put glue around the base of the cap and pushed the cap in place.
- Fixed in place with rubber bands until the glue was dry.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
