Thingiverse
FPV Camera Holder for 200mW_EACHINE_AIO
von TacomaD
9
Downloads
14
Likes
0
Makes
Simple Camera mount for AIO cameras for fixed wing aircraft and other vehicles that don't require a the camera to be tilted.
This was designed to work for my camera with the small display on the back. There is a small tab inside the mount to provide some pressure against the side of the circuit board that doesn't have the display. This tab can be removed if it doesn't fit correctly. In that case, a piece of double-sided foam tape works nicely to fill in the gap.
Be sure to do something with strain relief to keep the wires from getting pulled off the circuit board.
The mount can be secured with glue or small zip ties.
I'm assuming these tiny cameras aren't all assembled with the exact same tolerances, so your mileage may vary.
This was designed to work for my camera with the small display on the back. There is a small tab inside the mount to provide some pressure against the side of the circuit board that doesn't have the display. This tab can be removed if it doesn't fit correctly. In that case, a piece of double-sided foam tape works nicely to fill in the gap.
Be sure to do something with strain relief to keep the wires from getting pulled off the circuit board.
The mount can be secured with glue or small zip ties.
I'm assuming these tiny cameras aren't all assembled with the exact same tolerances, so your mileage may vary.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
