FPV Camera Mount (Foxeer T-REX)

FPV Camera mount bracket for mini (22mm) cameras.

Here is my bracket to mount a Foxeer T-REX mini FPV camera onto a pan servo. This should also fit most mini/22mm wide FPV cameras.

The lower hole has been slotted to allow +/-9° of tilt.

The base has no holes added to allow you to adapt it to any servo horn and also means it can be used to mount the camera on any flat surface.

To attach to a servo, use one of the double-sided servo horns. Mark out the hole pattern and screw directly onto the servo horn (to allow easy attachment/removal from the servo, drill a 5mm hole in the centre of the base to gain access to the screw that holds the horn onto the servo)

To attach to a surface, you can either glue directly or drill holes accordingly and screw/bolt to the surface.

For best print results, set the mount on its back (where the rear of the camera will be) and use 100% fill (or enough shells to completely fill the 2mm width) for max strength.

Comments and advice are alw