FPV Drone - 3D printable

This is a fully 3D printed drone. Step-by-step build instructions, setup procedures, and configuration guides can all be found in the downloads section. A fully specified BOM (Bill of Materials) is also available there.

---

# Print Guideline

Here are print guidelines for you to follow in order to have decent success with printing parts:

| Parameter | Value |
|---|---|
| **Infill type** | Gyroid, Honeycomb, Triangle or Cubic |
| **Material** | PCCF, PACF, ASA, ABS, PCTG, PETG, (TPU for Antenna Brackets) |
| **Infill percentage** | 35% |
| **Layer height** | 0.2mm, recommended |
| **Wall count** | Recommended: 4 |
| **Solid top/bottom layers** | Recommended: 5 |
| **Extrusion width** | 0.4mm, recommended |

---

# Tools

Needed or good to have tools for this project.

| Tool | Aliexpress | Amazon | Note |
|---|---|---|---|
| **Soldering Iron TS101** | [Aliexpress Link](#) | [Amazon Link](#) | *(Recommended)* |
| **Heat Inset Tip Kit - For TS101** | [Aliexpress Link](#) | [Amazon Link