Thingiverse
FPV Launch Pad
by dawen
9
Downloads
14
Likes
0
Makes
This is printed with PLA and 0.3 layer height. I used support touching build plate.
For the assembly a sharp knife should be used, to make it fit on the side, where the support was detached.
In the end everything is glued together to make it as strong as possible. On the top i placed some anti-slip mat (sorry for my english) with double sided tape.
For the assembly a sharp knife should be used, to make it fit on the side, where the support was detached.
In the end everything is glued together to make it as strong as possible. On the top i placed some anti-slip mat (sorry for my english) with double sided tape.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
