Thingiverse
FPV Mount for FPVRaptor
door BouncyMonkey
41
Downloads
37
Likes
0
Makes
This project is an FPV mount system to fit a Fat Shark camera and transmitter into the cockpit space of an FPVRaptor from HobbyKing.
Before we go too far I will say that this is NOT a tracking mount. It has a pivot in it so that the vertical alignment can be set up by the pilot to suit their desired view. The camera mount is designed to slot into the hole where a servo would go for a tracking camera mount. The transmitter holder is designed to be glued and taped down to the deck behind the camera.
Before we go too far I will say that this is NOT a tracking mount. It has a pivot in it so that the vertical alignment can be set up by the pilot to suit their desired view. The camera mount is designed to slot into the hole where a servo would go for a tracking camera mount. The transmitter holder is designed to be glued and taped down to the deck behind the camera.
BouncyMonkey publiceert ook op
3 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
