FPV Racer-X

The FPV Racer-X is a 220 sized quadcopter designed for FPV flight. It can be printed on a 200mm x 200mm or larger sized print bed. Heavily influenced by these two previous works.
http://www.thingiverse.com/thing:1248646
http://www.thingiverse.com/thing:1120168

This small quadcopter frame is a great trainer for FPV racing before spending a lot of money on a carbon fiber frame. Printed in ABS, PETG, or Carbon Fiber filament, this should be pretty rugged!

The USB port hole on the side is for a CC3D, but may fit other boards. The cutout on the top is also for a CC3D using the straight servo connectors. I will update both when I've had time to check a Naze32.

The FPV camera mount was designed to fit my cheap Eachine 700tvl CCD board camera that came bundled with an ET200 transmitter, but should fit most 32mm board cameras. A smaller camera with its own bracket, such as the HS1177 can be attached to the bottom plate.

Motor holes are sized for 22xx motors. There are