FPV Screen Enclosure

FPV screens are expensive for what they are so when I found a cheap FPV video system on banggood I decided to print a case for it. This has built in battries, charger, receiver, XT60 and screen cover. Its designed to be something you throw in your bag and pull out as needed without worrying about finding battries or antennas.

There are two main body parts one is if you want an internal lipo the other is without. There is a screen cover, a flap holder to hold the screen open and a back peice.

The antenna is built inside the case. The reception is good considering its sitting on a battery and metal screen. If you wish to charge using the USB connector you will need a slightly longer USB plug than normal.

Note: You are making something with built in Lipos & charging. Don't attempt this if you are not good at soldering or electronics. Try not to blow your house up!

--- Required parts ---
The screen and receiver board: https://www.banggood.com/RX5808-5_8G-48CH-FPV-Receiver-with