FPV whoop light weight

This is a whoop frame that can easily be printed without supports. There is two plates one for PLA/PETG and one for optional TPU parts.Motor mounts should be bend at the end of the thinnest part of the mount on each leg using hot water. I have used the following hardware with the frame: Motors: Happymodel - EX0802 19000Kv MotorAIO board: HappyModel DiamondF4 FR FCCamera: Runcam Nano 3 Camera3 small screws and 12 motor screws. You can use other hardware the board size and motor mounts should be the same as: