Thingiverse
FPVWRA SPEC - Motor Mount
door flexo_fpv
17
Downloads
5
Likes
0
Makes
This is my take on a FPVWRA Spec motor mount. This fits a thinner profile wing (1" root thickness - i.e. Minumum Spec) which i have been hot-wiring from pink rigid foam. It extends the motor appx 1/4" from the trailing edge of the root aerofoil. The goal was to get the cleanest flow over the wing to the motor.
The grooves in the profile snap over the carbon cross spars i place in the wing, appx 20mm from the trailing edge. The total weight comes in around 14g
Thanks for looking, any feedback is appreciated.
Feel free to request any variations of this design. If a different CG is required or different mounting pattern is needed, it should be easy enough to modify.
The grooves in the profile snap over the carbon cross spars i place in the wing, appx 20mm from the trailing edge. The total weight comes in around 14g
Thanks for looking, any feedback is appreciated.
Feel free to request any variations of this design. If a different CG is required or different mounting pattern is needed, it should be easy enough to modify.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
