Fractal Christmas tree
von PalRas
0
Downloads
0
Likes
0
Makes
Fractal Christmas tree
Having made this fractal figure, I thought that it - with a little good will and Christmas mood - might well resemble a Christmas tree !?
No support used, but in Cura 4.4.0 I found an Experimental feature called "Make Overhang Printable". I have enabled the function and applied the value 41 ° for "Maximum Model Angle".
I also used the "Enable Ironing" feature.
Merry Christmas (This was written on December 25, 2019)
Having made this fractal figure, I thought that it - with a little good will and Christmas mood - might well resemble a Christmas tree !?
No support used, but in Cura 4.4.0 I found an Experimental feature called "Make Overhang Printable". I have enabled the function and applied the value 41 ° for "Maximum Model Angle".
I also used the "Enable Ironing" feature.
Merry Christmas (This was written on December 25, 2019)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!