Fractal Node 304 HDD cage extender

Some HDDs have their mounting holes spaced further apart than normal. These drives won't mount properly in older Node 304 cases from Fractal Design, since only 2 out of the 4 screw holes line up. Even with the newer revision from Fractal, only 3 holes are usable. This part extends the bottom part of the metal bracket so that the last mounting hole can be used too, yielding either 3 or 4 mounting points total depending on the Node 304 version.

This remix retains the benefits of GiMo84's version, but is much easier to attach. Instead of a clip on the bracket's lower edge, it uses a "pin" that indexes into one of the bracket's smaller holes (intended for 2.5" drives). It is flush with the bracket's inner face, and the "mushroom cap" is only 0.5mm tall, so it will not compromise the vibration dampening grommets.

To install, turn the extender 90 degrees while lining up the mushroom cap with the unused large rubber-grommet hole. The extender should point outwards from the bracket. The