Thingiverse
Frame hangers for canvas frames
door Gryphon304
13
Downloads
5
Likes
0
Makes
Little helpers for hanging a canvas frame perfectly.
Screw the straight one on one side of the frame and the angled one on the other. Now you can shift the canvas to the left or right to hang it perfectly in level. Each notch will lower/heighten by ~0.5mm.
The holes are made to take 2x10mm Spax screws.
Each part has a little indicator for the middle so it's easier to measure.
For convenience, I put the .stl's already "upside down", so you can just drop them into your slicer and print easily.
Screw the straight one on one side of the frame and the angled one on the other. Now you can shift the canvas to the left or right to hang it perfectly in level. Each notch will lower/heighten by ~0.5mm.
The holes are made to take 2x10mm Spax screws.
Each part has a little indicator for the middle so it's easier to measure.
For convenience, I put the .stl's already "upside down", so you can just drop them into your slicer and print easily.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!