Framework Card Holder

A little card holder for framework cards that rotates outwards and locks into place when rotated back in. Doesn&#39;t work for the Ethernet card or any other non standard form factor card (As in when slid into laptop doesn&#39;t extend past edges of its slot). Special Thanks to my beta tester that gave me valuable feedback to improve the model <3.(Edit added reinforced slide so the handle doesn&#39;t break as easily i would recommend using this version but other is still available)As for print settings i would recommend.2mm layer heightPrint thin wallsHaving the housing lay flat with hole face upHaving card holder flat hole facing strait up.4mm nozzle (It works perfect with a .4 mm nozzle might not work for larger sizes but should for smaller haven&#39;t tested though)AssemblyAfter making sure the pin at bottom lines up with the pin slot in the holder slide the card backwards and then push down a bit and it should click into place. Don&#39;t use to much force though.A little card holde