Freak kit Cigar case v1

This is another case to hold freak inserts.

This version uses two hinged lids. The lids are held closed with small 1/4" magnets i picked up from home depot:
https://www.homedepot.com/p/Master-Magnet-1-4-in-Dia-Neodymium-Rare-Earth-Magnet-Discs-with-Foam-Adhesive-12-Pack-97584/206503481

Use a piece of filament for the hinge pins, or use nails or metal rod. Designed as a 2mm hole, so anything about 1.8 after accounting for printer tolerances.

Holds eight inserts. I recommend a little padding in the lids to help prevent rattling.

There is also an untested version for Freak XL inserts.

Enjoy! Please do not sell these. It's fine if you make them for friends and team mates, but please don't try to profit off of my work and my willingness to share with the community.

Thank you!