Freaky Pumpkin

Inspired by Megawillbot https://www.thingiverse.com/thing:3129886 but my own design.

Pumpkin spins to open up and expose the freaky pumpkin face.

Print Instructions

Right Eye, Left Eye, Teeth, Neck - 1 each - 0.16 layer height, no supports, print neck on triangular end.

Arms - 12 - 0.2 layer height, no supports, print on side so holes are horizontal

Core - 1 - 0.2 layer height, no supports, print with neck opening (triangle opening) down.

Base - 1 - 0.2 layer height, no supports

Slice - 6 - 0.2 layer height, print outside surface up with brim (or raft) and supports inside. Support the arm pivot extensions only on the very end. Support the arched surface but leave some clearance around the pivot arm extensions.

All of the slice and arm pivot joints are designed to pivot around filament hinge pins. The filament is inserted through the slice and core hinge holes and capture the hole in the arm. Use needle node pliers to flatten the filament pin on the outs