Thingiverse
Free Flight Glider Winch
door Styx2015
7
Downloads
19
Likes
0
Makes
After watching Maxfliart launch his free flight glider with a modified indoor winder, I was inspired to make a fully 3D printable version.
Google Maxfliart and watch some amazing flying and building videos.
Thanks to janssen86, the gears were generated using his Openscad software:-https://www.thingiverse.com/thing:1587846
The winch has a 10:1 ratio and turning the crank 1 revolution per second produces a good walking pace speed.
The winch so far has not been tested with a glider.
My version was printed on a Fortus 380mc in ABS and as yet I have not printed a PLA version.
Below is the list of items needed to complete the winch, all readily available.
4 Off 10x15x4 Bearings
3 Off 5x10x4 Bearings
8 Off M3x16 Countersunk Screws (Lid)
1 Off M3x8 Grub Screw (Spool Gear)
5mm Dia x 20 Silver Steel (Drill Rod) Flat one end for grub screw. 4mm protruding from face of spool gear.
M3x20 Cap Head (spool attachment)
M3x29 Cap Head (handle to crank)
M3 Nyloc Nut (handle to crank)
5m
Google Maxfliart and watch some amazing flying and building videos.
Thanks to janssen86, the gears were generated using his Openscad software:-https://www.thingiverse.com/thing:1587846
The winch has a 10:1 ratio and turning the crank 1 revolution per second produces a good walking pace speed.
The winch so far has not been tested with a glider.
My version was printed on a Fortus 380mc in ABS and as yet I have not printed a PLA version.
Below is the list of items needed to complete the winch, all readily available.
4 Off 10x15x4 Bearings
3 Off 5x10x4 Bearings
8 Off M3x16 Countersunk Screws (Lid)
1 Off M3x8 Grub Screw (Spool Gear)
5mm Dia x 20 Silver Steel (Drill Rod) Flat one end for grub screw. 4mm protruding from face of spool gear.
M3x20 Cap Head (spool attachment)
M3x29 Cap Head (handle to crank)
M3 Nyloc Nut (handle to crank)
5m
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
