Freelancer Nomad Battleship Printable sections

Built in Glow in the Dark PLA to give it that otherworldly feel this I split this to fit a printer with a 120x120x120mm print area. Section 3 gave me some problems. Check your support settings when making it or you'll end up with some spaghetti. If you have editing software I suggest breaking it into two halves again so it can print with minimal need for support. Part 4 is all 3 fins as one group but there are individual fins (they are different because of how I cut them from the original model. (I have limited editing tools and skills). if you need to print each fin individually they are available. This time I included a master file with all the parts split. Cura settings:
Layer height 0.1mm
shell thickness 0.8mm
Retraction Enabled (min ravel 1.5, min extrusion: 0.02mm, z-hop: 0mm)
Bottom/Top thickness 0.6mm
Fill Density 10%
Print Speed 50mm/s
Print Temp 215C (Depends on printer and Plastic)
Bed Temp 55C (Depends on printer and Plastic)
Support Everywhere
Raft
Diameter 1.75