Thingiverse
Fridge Card Holder
door we_print_4_fun
1
Downloads
8
Likes
0
Makes
I needed something to hold all the grad party invites rolling in. Putting each one on the fridge was taking up too much space, so I created a simple holder to keep them all in one place.
This uses 6mm x 3mm magnets as those were the only ones I had at home at the time.
Materials and settings for my print:
PLA
.20mm layer height
10% Infill
Supports on
Magnets used - 16 - 6mm x 3mm. I purchased mine from Amazon: https://a.co/d/02P8KtbS
This uses 6mm x 3mm magnets as those were the only ones I had at home at the time.
Materials and settings for my print:
PLA
.20mm layer height
10% Infill
Supports on
Magnets used - 16 - 6mm x 3mm. I purchased mine from Amazon: https://a.co/d/02P8KtbS
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
