Fridge Handle

This was designed to repair the handle of a fridge, using a steel broomstick (22mm diameter) which I did cut to the required length. This is fixed with M4 screws (4.5mm hole in design).

The only relevant dimensions to consider are the 22mm diameter for the bar and the fact that the hole for the screw is located 18mm from the edge. If different, mods are required.
The distance between the top and bottom parts is irrelevant as it can be adjusted when cutting the cylinder that will be used as bar.

I did simplify the original design, however this is design as a quite solid piece, likely over-dimensioned. It can certainly be optimized to save some time in printing, which anyway is quite reasonable already. This heavy duty handlebar is likely to last longer than the original one !

------------------------------------------

J'ai préparé ce design pour réparer la porte d'un frigo / congélateur. La poignée est constituée à partir des 2 éléments imprimés et une section de manche à b