Thingiverse
Fridge Latches (Keep It Closed)
par Simon_Says_
15
Téléchargements
8
Likes
0
Makes
Hi I hope you found this design useful.
It helps with keeping the fridge closed with super easy installation (literally any decent adhesion will do). Because the fridge belongs to the landlord I cannot use anything permanent, which is not the best looking, it works perfectly.
With 0.3mm resolution it takes around 30 min to print. I think it should take less than 20 min if the resolution is higher.
It helps with keeping the fridge closed with super easy installation (literally any decent adhesion will do). Because the fridge belongs to the landlord I cannot use anything permanent, which is not the best looking, it works perfectly.
With 0.3mm resolution it takes around 30 min to print. I think it should take less than 20 min if the resolution is higher.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
