Frisbee Printer Test

This print can be used test your printer and help you fix problems with your printer and or slicer. looking at the bottom of the print, you can see how level of your bed is and or the desired z-offset. The individual lines you see on the bottom are the result of your bed being too low compared to where the printer tried to print, on that side/too high on the other (shown in pictures 2 and 3). When the lines are squished together and uniform you know that your high and z-offset are good (picture 4), but if they push extra material to the sides, your bed may be high in that spot. This part of the print is best seen on nontextured plate. On the top outer edge, you should see steps in the layer lines (picture 5), this will show you how your printer and slicer handle the sloped surface. On the top of the print (picture 6), you can see the top layer finish and ironing, if enabled, you can also see if your support percentage or style work for you. In Image 6 you can see how the underlying inf