Thingiverse
Froctopus
di bisquick5
150
Download
590
Likes
0
Makes
Froctopus: the frog octopus.
Printed this little guy at 12% infill with no issues, though I think 15% would make him pretty sturdy. Especially if you plan on using him more often/like to fidget with your prints, 15% is better for his leg strength. If he's just a fun desk piece, 12% is fine.
Supports are a must for his little chin. Raft not necessary, but I like to print with a brim.
He's currently a work in progress due to his back. The original frog design looks pretty cool to me, but his back has a few spots that look unfinished (see second to last photo). If you like the pattern the printer makes, then he's set. But I'm a bit of a tinkerer, so I'm going to try to smooth it/correct it in a later update.
When uploaded into Ultimaker Cura, he gives a warning; however, after slicing, no errors persist. He's printed at 74.36% of his original size.
A big thank you to the two original designers whose models I used to put froctopus together. As I said, I'm a tinkerer--not
Printed this little guy at 12% infill with no issues, though I think 15% would make him pretty sturdy. Especially if you plan on using him more often/like to fidget with your prints, 15% is better for his leg strength. If he's just a fun desk piece, 12% is fine.
Supports are a must for his little chin. Raft not necessary, but I like to print with a brim.
He's currently a work in progress due to his back. The original frog design looks pretty cool to me, but his back has a few spots that look unfinished (see second to last photo). If you like the pattern the printer makes, then he's set. But I'm a bit of a tinkerer, so I'm going to try to smooth it/correct it in a later update.
When uploaded into Ultimaker Cura, he gives a warning; however, after slicing, no errors persist. He's printed at 74.36% of his original size.
A big thank you to the two original designers whose models I used to put froctopus together. As I said, I'm a tinkerer--not
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
