Front panel for the Chieftec BT02 chassis

While building an [ITX-Llama](https://docs.retrodreams.ca/itxllama/) system using a [Chieftec BT-02B](https://www.chieftec.eu/products-detail/93/BT-02B-U3-250VS) case, I was missing a few buttons and knobs on the front, hence this build.

This project is a new 5.25"-ish front panel for the BT-02 that fits in the optical drive opening. No cutting or breaking of the original case required. The new front plate has controls for the MT32-Pi, a switch for selecting the MT32-Pi or the GS Wavetable board, a reset button and a MicroSD slot.

#### Requirements

You'll need these parts for the build:

* MT32-Pi control board:
* 9x12 hole Stripboard/Veroboard with 2.57mm spacing
* 1 x Rotary switch with Ø6.75 stem and 12x12mm box with no tap (standard China model also used in Gotek projects)
* 2 x PCB buttons with 9mm stem and total height of 13mm
* 2 x hats for buttons (Ø5.5mm)
* Knob for rotary button
* Pin header, depending on your design choice (I used 2x9 to be able to daisy chain