Thingiverse
Frosthaven Condition Tokens
von ZippyZip
5
Downloads
14
Likes
0
Makes
Why did I make these? Because I own a 3d printer, no better reason than that.
The tokens are 15mm in diameter and 3mm high. They are designed to be filled with epoxy resin (that's why they look shiny in the photo).
Using prusa slicer: I first printed the base of the token in an appropriate color or printed the base a close color and then painted the bases while still on the build plate without removing the build plate from the bed. Filament has no problem adhering to the paint.
Then I printed the tops by using a 1mm Z offset (the bases are 1mm thick) with a travel lift of 2mm set to only lift when below 1.2mm. This avoids any collisions with the previously printed base.
Each token will hold approximately 0.3 - 0.5ml of resin. I mixed up 40mls total of resin and that was enough for over 80 tokens including wastage.
The tokens are 15mm in diameter and 3mm high. They are designed to be filled with epoxy resin (that's why they look shiny in the photo).
Using prusa slicer: I first printed the base of the token in an appropriate color or printed the base a close color and then painted the bases while still on the build plate without removing the build plate from the bed. Filament has no problem adhering to the paint.
Then I printed the tops by using a 1mm Z offset (the bases are 1mm thick) with a travel lift of 2mm set to only lift when below 1.2mm. This avoids any collisions with the previously printed base.
Each token will hold approximately 0.3 - 0.5ml of resin. I mixed up 40mls total of resin and that was enough for over 80 tokens including wastage.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!