Frosthaven Overlay: Pine Tree

I made this Pine Tree to be used in place of the Frosthaven 3-hex overlay, but it'll work in any sort of TTRPG as well! To give it some more utility, I made the canopy and the trunk as separate parts. When aligned properly, the canopy can slide down over the trunk for a healthy tree, or if you're looking for a "deadlands" vibe, just use the trunk by itself! Lining it up is a bit tricky, but once you know how to do it, it's not too bad.

If you look at the base of the trunk piece, it's basically got three sections, one with one rock, one with two rocks, and one with three rocks. If you look at the underside of the canopy, you'll see that it's an irregular pentagon (as seen in the second screenshot). To line them up, you want the point of the pentagon made by its two longest sides (facing up in the screenshot) to point towards the one-rock section of the base.

No supports are required for this model, as the canopy has a nice flat bottom and is designed to be printed directly on the