MakerWorld
Electronics
Go to Model
Frozen Controller Stand for Xbox Series Controller
50
Downloads
24
Likes
9
Makes
This stand is for Xbox Series Controllers ONLY. This model prints in 2 pieces which then slides together easily (superglue not needed but recommended). It prints in 2 pieces because it is the best way I have found to print the model using supports. There is another model that prints all in one piece if you want to try to print it in one piece, but as a warning I have not found the best support settings for this version yet, if you make any suggestions feel free to let me know :) There are two rods that act as custom made supports for the model, they are made to break off easily. I have a PS5 version in my profile if you want to check it out
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
