Thingiverse
Frsky X-Lite Stickend
3
Downloads
0
Likes
0
Makes
I wanted a simple and short stickend to my X-lite so i designed this.
It only raise 2mm over the threaded shaft and has a little bowl at the top.
The diameter is 10mm.
I printed this in TPU to get a good grip, i can press it down the whole way without screwing and it stays there. Don´t know how it will work with PLA or other hard filaments.
It only raise 2mm over the threaded shaft and has a little bowl at the top.
The diameter is 10mm.
I printed this in TPU to get a good grip, i can press it down the whole way without screwing and it stays there. Don´t know how it will work with PLA or other hard filaments.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!