Thingiverse
Fashion
Go to Model
#fsociety mask
359
Downloads
267
Likes
2
Makes
One of the fine folks on reddit did me the favor of scanning a mask they received from a USA network contest using the 123D Catch app ([original scan here](http://www.123dapp.com/catch/FMask/4634410)). I cleaned up the mesh as best I could in MeshMixer and Sculptris.
The eyes, nostrils, mouth and elastic holes still need to be cut out of the model, but I'm not sure how to go about that with a raw mesh like this. I'm open to suggestion for the right tools to move this project along.
In my print, I ended up using a Dremel to cut out the eyes and mouth slit.
The eyes, nostrils, mouth and elastic holes still need to be cut out of the model, but I'm not sure how to go about that with a raw mesh like this. I'm open to suggestion for the right tools to move this project along.
In my print, I ended up using a Dremel to cut out the eyes and mouth slit.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
