Thingiverse
FT-70D battery case
door D3V1N
14
Downloads
10
Likes
0
Makes
Yaesu FT-70D battery case made to fit 18650s and BMS board.
A 10k ohm thermistor to ground is needed for the center contact for the FT-70Ds onboard charger to work. The fit in the battery case it self is very tight and may need to be modified to fit needs. I used cut down nickle spot weld battery tabs to use as contacts. After placing contacts I suggest using epoxy on the inside to prevent short. I suggest the use of a BMS with 18650s due to the way 18650s fail. I will be using pre tabbed 18650s to save space and I don't have a spot welder.
A 10k ohm thermistor to ground is needed for the center contact for the FT-70Ds onboard charger to work. The fit in the battery case it self is very tight and may need to be modified to fit needs. I used cut down nickle spot weld battery tabs to use as contacts. After placing contacts I suggest using epoxy on the inside to prevent short. I suggest the use of a BMS with 18650s due to the way 18650s fail. I will be using pre tabbed 18650s to save space and I don't have a spot welder.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!