FT Dart power pod

UPDATE 3/21/18: I revisited the dimensions in both the original pdf plans and F360, and found the perimeter was slightly smaller than it should have been. I have replaced the original stl and gcode files with a newer v2 model with corrected dimensions. Thanks to [jhitesma](https://www.thingiverse.com/jhitesma/) for the feedback!

UPDATE 3/20/18: It has been noted that the ID of the piece may be too small and not allow the foam pod to be inserted, [see comment](https://www.thingiverse.com/thing:2828661/#comment-1816444). This may be due to variation in printers or software, but scaling the print slightly will give the proper ID. If you have the same experience please let me know so I can update accordingly. I will continue to research this and update if needed.

Printable power pods for the FT Dart from Flitetest. I wanted to duplicate the plywood firewalls that are included with the speed build kit. These are based on the plans by [Dan Sponholz](https://www.thingiverse.com/SP0NZ/ab