Thingiverse
FT Mini Arrow Fuselage
von JerryBoi831
40
Downloads
25
Likes
0
Makes
I was fed up with many other options out there that print like crap in ABS and cause curling, cracks, etc. So i designed this from scratch and meant to be printed in pieces then either epoxied or crazy glued together.
printed in .2 layer height and 35% infill. you can print solid but that's up to you :) recommended to acetone rub it after to make it even stronger if printed in ABS.
Enjoy! Parts may need some light sanding to make them fit snug but nothing hard
printed in .2 layer height and 35% infill. you can print solid but that's up to you :) recommended to acetone rub it after to make it even stronger if printed in ABS.
Enjoy! Parts may need some light sanding to make them fit snug but nothing hard
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
