Thingiverse
Engineering
Go to Model
FTC Flywheel
0
Downloads
0
Likes
0
Makes
Adds weight to our launcher for 25-26 FTC Decode.
5mm Hex shaft
For 1/2in washers- holds 30 washers (about .46lbs)
By changing the height you can change the number of washers and thus the weight.
Fits in between Jelly Wheels
The print pause print version fits 24 washers for a combined weight of 7.5 ounces. A pause should be inserted around layer 65 depending on layer height.
This is the version we went with as it is sturdier.
5mm Hex shaft
For 1/2in washers- holds 30 washers (about .46lbs)
By changing the height you can change the number of washers and thus the weight.
Fits in between Jelly Wheels
The print pause print version fits 24 washers for a combined weight of 7.5 ounces. A pause should be inserted around layer 65 depending on layer height.
This is the version we went with as it is sturdier.
silas4 also publishes on
1 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
