FTC Motor Wire Clip

Available in stl (inches or millimeters).

A two-part 3D print that allows can be mounted to Actobotics® standard channel. The 6 wires slots are for (4x) 22AWG Encoder Wires and (2x) 16AWG Power Wires.

All holes use 6-32 bolts. Those that mount the piece to the frame require a nut. The top piece that is fastened to the bottom does not require a nut. This is because the hole is smaller diameter at the bottom piece, allowing for you to thread it with a tap, or just use the bolt, and force it through the plastic.

**NOTE: ** May cause damage to wires if you overtighten the top piece.