Slicer Discord
3DSEARCH / FTC Power switch mount
FTC Power switch mount – 3D-Druckmodell von Thingiverse Thingiverse

FTC Power switch mount

von eXtremeRobot
10 Downloads
7 Likes
0 Makes
Zum Modell
This can be mounted on a side of a tetrix C channel or plate. The mount is centered and does not allow the switch to hang over the edge. Our FTC team mounted the switch on the back of our robot. This design allows the metal C channel to be the farthest back part of our robot.
Quelle
Thingiverse
Was du zum Drucken brauchst: Anfänger Niedrige Konfidenz
Einteilig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
FTC Centerstage Single-Servo Claw
FTC Centerstage Single-Servo Claw
von barbarianlibrarian
↓ 25 ♥ 38
FTC Odometry Pods for goBILDA Channel - Upgraded (Remix of FTC9794)
FTC Odometry Pods for goBILDA Channel - Upgraded (Remix of FTC9794)
von 12043_Power_Surge
↓ 6 ♥ 3
FTC 4-pin cable converter to JST Retention Clip
FTC 4-pin cable converter to JST Retention Clip
von 12043_Power_Surge
↓ 6 ♥ 8
FTC intake Zip tie mount for 5mm hex shaft
FTC intake Zip tie mount for 5mm hex shaft
von qjdugger
↓ 5 ♥ 1
FTC Anna 90
FTC Anna 90
von pochetl
↓ 3 ♥ 3
FTC Rev Color sensor Mount
FTC Rev Color sensor Mount
von qjdugger
↓ 2
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
· Impressum · Datenschutz
DE EN FR ES IT NL

Zur Sammlung hinzufügen