Thingiverse
FTX Vantage spoiler bracket
von jonnyg30
16
Downloads
5
Likes
0
Makes
Replacement spoiler bracket/pad for the FTX Vantage.
Print in supplied orientation with supports. printed in ABS at 0.2mm layer height, 20mm/s with +2% axis increase, print took 24 mins.
you may need to clean the R-clip hole out with a PCB screwdriver or a small drill bit, if you try to just force the pin through you will snap the spigot off.
More parts will become available as I continue to break them...........
Print in supplied orientation with supports. printed in ABS at 0.2mm layer height, 20mm/s with +2% axis increase, print took 24 mins.
you may need to clean the R-clip hole out with a PCB screwdriver or a small drill bit, if you try to just force the pin through you will snap the spigot off.
More parts will become available as I continue to break them...........
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
