府河斜拉桥（Fuhe Cable stayed Bridge）

大家好，今天给大家展示的是位于中国成都的府河斜拉桥，它的造型简洁优美，是成都的网红地标之一！ Hello everyone, today we are presenting the Fuhe Cable stayed Bridge located in Chengdu, China. Its simple and beautiful design makes it one of the internet famous landmarks in Chengdu! 为了更好的通过模型展现它，我根据它的造型进行了设计！并使用AC公司的切片软件进行切片打印。 In order to show it better through the model, I designed it according to its shape! Slicing software of AC company is used for slice printing. 模型主要分为4个配置文件，下面介绍一下模型拼装步骤，首先准备好强力胶水。 The model is mainly divided into 4 configuration files. The model assembly steps are described below. First, prepare strong glue. 步骤1：先将前主梁上三个销插入后主梁的对应销孔，观察下两者间的间隙是否紧密，如不紧密，需对销或孔修整后组装，并通过胶水粘接牢固。 Step 1: First, insert the three pins on the front main beam into the corresponding pin holes on the rear main beam, and observe whether the gap between the two is tight. If it is not tight, the pins or holes need to be trimmed before assembly, and firmly bonded with glue. 步骤2：按图将下塔柱安装于前、后主梁底部（注意方向，不要装反），胶水粘接牢固 Step 2: Install the lower tower column at the bottom of the front and rear main beams according to the drawing (pay attention to the direction, do not install reversely), and glue firmly 步骤3：按图将上塔柱安装于主梁上部（注意方向，不要装反），胶水粘接牢固 Step 3: Install the upper pylon column on the upper part of the main beam according to the drawing (pay attention to the direction, do not install reversely), and glue firmly 步骤4：从上塔柱底部向上依次安装后锚杆，后锚杆插入后，可以自由选择是否需要胶水加固！ Step 4: Install the rear anchor rod from the bottom of the upper tower column upward in turn. After the rear anchor rod is inserted, you can freely select whether glue is required for reinforcement! 步骤5：安装前锚杆，前锚杆插入后，可以自由选择是否需要胶水加固！组装完成！ Step 5: Install the front anchor rod. After inserting the front anchor rod, you can freely choose whether adhesive reinforcement is needed! Assembly completed! 下面介绍一下打印参数设置：（Below is an introduction to printing parameter settings:） 材料：PLA（Material: PLA） 喷嘴：0.4mm（Nozzle: 0.4mm） 层高：0.2mm（layer height: 0.2mm） 填充图案：网格(Fill pattern: grid) 填充密度：15%(Filling den