Full Graphic Smart LCD Controller & 2020 Bracket

This case was derived from a few different models and tweaked for my purpose.

The bracket is meant to be screwed into the captive M4 Nyloc and use a washer between case and bracket to provide the amount of "slip" you need.

You can choose to fix it from the left or right. The opposite side I just screw in a M4 caphead bolt to act as the other side hinge. Note: you don't need to put nut and bolt on both sides, just one and the other loose

2 - M4 x 40mm for hinges
1 - M4 Nyloc Nut

2 - M5 x 15mm and nuts for the 2020 extrusion.

4G Screws (Case)

4 - x 15mm
4 - x 8mm