Thingiverse
Fullspeed Leader 3 Improved Canopy
von PadMack
5
Downloads
6
Likes
0
Makes
This is an improved canopy for the Fullspeed Leader 3 Drone
This canopy was designed to stop the flight stack from getting damaged in a crash when the original canopy gets pushed down into it.
The new canopy comes up and over the carbon fibre sideplates to give much better protection to the sideplates. Also in a crash this canopy won't get pushed down into the flight stack.
Designed to be printed in TPU
New Updated Version with the Antenna hole at an angle behind the fin.
2021 Version - lightened slightly.
This canopy was designed to stop the flight stack from getting damaged in a crash when the original canopy gets pushed down into it.
The new canopy comes up and over the carbon fibre sideplates to give much better protection to the sideplates. Also in a crash this canopy won't get pushed down into the flight stack.
Designed to be printed in TPU
New Updated Version with the Antenna hole at an angle behind the fin.
2021 Version - lightened slightly.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!