Thingiverse
Fully 3D Printable Model Rocket
by Zorse
166
Downloads
106
Likes
0
Makes
A fully 3D printable model rocket. Fits a standard Estes 1/8" launch rod and works with Estes C engines.
Tolerances may need to be adjusted depending on your printer.
This model includes the NASA logo because I was working there at the time and the Syracuse logo because I attend Syracuse University. I cannot suppress these features without messing up the model, sorry :)
Two-Stage Version can be found here: https://www.thingiverse.com/thing:3794565
Weight (unloaded): ~90g
Launch Height: A few hundred feet
Recovery: Parachute
Material Cost (PLA): ~$2.5
Tolerances may need to be adjusted depending on your printer.
This model includes the NASA logo because I was working there at the time and the Syracuse logo because I attend Syracuse University. I cannot suppress these features without messing up the model, sorry :)
Two-Stage Version can be found here: https://www.thingiverse.com/thing:3794565
Weight (unloaded): ~90g
Launch Height: A few hundred feet
Recovery: Parachute
Material Cost (PLA): ~$2.5
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!