Fully 3D Printed Balisong

This is a balisong that i have designed. Just print the two files that say READY. The tolerances are fairly tight so make sure your printer is well maintained. Also i suggest waiting for your bed to cool down before removing the print, or else it can warp it and it wont fit properly.

IMPORTANT: PRINT THE PINS WITH 80% INFILL AND O.12 RESOLUTION. Also print the handles with 2 line thick mouse ears near the ends. You may also use a brim but that didnt work well for me as it wasnt thick enough.

FYI: If you drop it on hard floor to much, the pins will fall out. I recommend putting a small amount of glue on the side or on the top of the pin, be careful to not glue the blade to the pin.

Comment any suggestions/changes you want to see.