Thingiverse

Fully 3D Printed Compact Camera Grip

by M_JM

36 Downloads

45 Likes

0 Makes

This is a compact camera grip that I made since I wanted a small grip I could maybe use with my phone when filming. I looked on Thingiverse for Grips and Tripods but couldn't find anything that didn't require extra screws, nuts, bolts, tools, etc. So I just went in Fusion 360 and made my own Grip.

Instructions:
Step 1: You will first need to print one of each part. There are five parts. Make sure to print Main Screw at 101-102 percent scale (Not required though recommended by me).
Step 2: For this step you will need some super glue, this is probably the most important part. First you will need to take the Main Screw Enclosure, Main Screw, and the Pivot Point. With the Main screw sticking out the top of the Main Screw Enclosure, glue the bottom of the Main screw enclosure to the top (Flat Side) of the Pivot point.
Step 3: Take the handle and insert it between the legs of the Pivot Point.
Step 4: Now take the Pivot Point Screw and insert it. Make sure that the threaded side of the

accessories accessory camera camera mount delta fully printable grip holder Monoprice mini mount stabalizer tripod webcam accessories accessory camera camera mount delta fully printable grip holder Monoprice mini mount stabalizer tripod webcam

Source

Thingiverse

What you need to print this: Intermediate Low confidence

Why?

significant post-processing

Single piece Hardware needed

Supports 1/3

Assembly 0/3

Settings 1/3

Bed size 0/3

Post-process 2/3

Printer