Fully 3D printed Speaker V12

***This speaker uses v11: Project metal hearts motor- consult that model for the motor files***

https://www.thingiverse.com/thing:6117720


^^ Project Metal Heart -

This is the basic components of a 3D printed speaker; you need to add magnets and copper wire, Along with getting the 4 plates cut from a local or online laser cutter(Look at project metal heart-V11)

The Surround should be printed in TPU or this speaker may not work. I used Varioshore Foam but it should work with everything from 85A-97A it will just change the frequency response (higher shore hardness = high frequency response-- 85A will act like a small woofer and 97A should act like a mid)

Magnets are as follows (Project metal Heart)

8 - 12.7mm (½") diameter by 9.7mm (3/8") mm height - n52
*** MAGENTS OF THIS SIZE CAN START TO BECOME DANGEROUS, THEY CAN SHATTER IF LET FLY TOWARDS EACH OTHER, AND CAN ALSO PINCH AND CUT SKIN, ESPECIALLY WHEN USED WITH SHARP LASER CUT STEEL- USE THESE DESIGNS AT YOUR OWN R