Thingiverse
Fully Diy Respirator
door Flyingrobot910
15
Downloads
9
Likes
0
Makes
A 3d-printable respirator design that only requires a few materials to make. Use this design at your own risk, it is not tested.
To make:
1. Print mask1.stl and mask2.stl(mask1 in a flexible filament, mask 2 in PLA)
2. Add wool/makup pad/cotton into the hole of mask2, as a filter
3. Screw mask2 into mask1
4. Add elastic band into the holes of mask1
5. Make sure to add a seal between mask1 and mask2
To make:
1. Print mask1.stl and mask2.stl(mask1 in a flexible filament, mask 2 in PLA)
2. Add wool/makup pad/cotton into the hole of mask2, as a filter
3. Screw mask2 into mask1
4. Add elastic band into the holes of mask1
5. Make sure to add a seal between mask1 and mask2
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
