Thingiverse
Fully printable PCB vise
von sneakypoo
13.3k
Downloads
10.1k
Likes
157
Makes
Pretty self explanatory, it's a vise to hold PCBs steady when you are soldering your components.
The ball joint design gives you a fair bit of movement to position your work where it is most comfortable.
The main drive screw has reverse threads on one side to make the jaws clamp your PCB right in the middle of the vise.
The base has a few square holes for magnets to keep it steady on your workbench.
The vise can hold PCBs with a maximum width of 10cm.
The ball joint design gives you a fair bit of movement to position your work where it is most comfortable.
The main drive screw has reverse threads on one side to make the jaws clamp your PCB right in the middle of the vise.
The base has a few square holes for magnets to keep it steady on your workbench.
The vise can hold PCBs with a maximum width of 10cm.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
