Thingiverse
(Fully printed*) Gamepad
di eemanon
5
Download
7
Likes
0
Makes
Version I of a retro gamepad. Basically, it's a "button study" to see what is possible to realize with PLA.
So I developped this as an easy way to have many (cheap) controllers for decent multiplayer of retro games programmed on my raspberry pi.
You may need some (I recommend hot) glue to hold the springs in place and stop the wires from moving and cables. For the circuit you need some 10k Ohm resistors (and some 1k Ohm resistors for gpio in protection)
*the wires can't be printed (yet)
So I developped this as an easy way to have many (cheap) controllers for decent multiplayer of retro games programmed on my raspberry pi.
You may need some (I recommend hot) glue to hold the springs in place and stop the wires from moving and cables. For the circuit you need some 10k Ohm resistors (and some 1k Ohm resistors for gpio in protection)
*the wires can't be printed (yet)
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!