Fun Funnel

This thing is HUGE!! It can be done on an Ender-3 though.

This is a piece to an interactive candy dispenser I made to sling m&ms all over the room. loaded the funnel and they'd roll down the slide and turn on a "Ferris-wheel" to go down another slide. Then they'd drop into a spoon and when you hit the button the spoon would launch them into the air.

So the funnel I printed in PLA and used the outer spiral feature. Turned out awesome!! The slide I was able to print with very little supports.. The overhangs are all slightly uphill so technically you don't need supports its just that the center of balance isn't quite over the area touching the build plate so if you don't get great adhesion it may tip over..

Check out my other stuff to get more pieces.

*These pieces I made a few years ago and I'm sure they were heavily remixed from others on here. Thanks for getting me started!!