Thingiverse
Funbot hotend mount no sensor
von b3n3d1k7
1
Downloads
0
Likes
0
Makes
Just some slight improvements of the hotend mount.
Closed the holes for the nuts on the bottom - this makes it a lot easier to disassemble/assemble the hotend on the printer - e.g. for maintenance - as the nuts dont fall out all the time.
Also reduced the size of the base a bit.
Closed the holes for the nuts on the bottom - this makes it a lot easier to disassemble/assemble the hotend on the printer - e.g. for maintenance - as the nuts dont fall out all the time.
Also reduced the size of the base a bit.
b3n3d1k7 veröffentlicht auch auf
50 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!