Funny art IX. [HelloDarkness] HueForge

Picture source/Author: @fredwardfallThen used HueForge v0.8.1 to create the model.Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm.Size 150x150mm. Do not adjust the height (Z) in your slicer! The layers would not be correct. You can only modify the X and Y dimensions. You may print at higher layer heights below the Min Depth of 0.48mm. The Max Depth is 2mm and the Actual Depth is 2mm. It is possible to print without AMS by manually changing the filament (setting filament change or pause) in the slicer, depending on your printer and sw support.Filaments Used: PLA Elegoo+ Black Transmission Distance: 0.3 PLA Elegoo + Gray Transmission Distance: 3 PLA Aurapol Beige Transmission Distance: 2.4 PLA Elegoo + White Transmission Distance: 7This print uses 4 unique filaments Swap Instructions: Start with Black At layer #9 (0.8mm) swap to Gray At layer #15 (1.28mm) swap to Beige At layer #17 (1.44mm) swap to White for the rest.Share your prints, and…Boost MeThank you