Furniture Pads

These are floor protectors. On the first plate the floor protector accepts a ¾ inch felt pad. This allows the chair to slide around smoothly on the floor. On the second plate the floor protector is solid tpu and is non slip. Drill a half inch hole in the bottom of the chair leg and push the pad into the hole. If the hole is loose, use some hot melt glue to hold in place. The third and fourth plate do not require you to drill a half inch hole and the pads are screwed into the furniture legs. These will be easier to install for most people and I should have done this myself but didn't think of it until later. I was concerned about having screws at the bottom of the floor protectors and if one of them came off it would damage the floor. If you use screws please make sure they are very secure. I think that TPU should be used to make these because I don't know if pla or petg will not scratch your floors.